MF50 Anti Leak tape is a self-fusing silicon tape for emergencies and all-purpose repairs. MF50 can be applied on a wide range of surfaces. The tape has many uses including the repair of leaking pipes and hoses, protection of electrical connections, cables, hand tool handles and much more.
Anti Leak Tape is resistant to UV, fuel, water, oils, acids, and wide range of solvents. The tape creates a permanent air-tight and water-tight seal immediately after application. It ensures anti-corrosive and electrical protection. It is very easy to remove and leaves no sticky residue on the elements it covered.
The installation process takes only a few minutes and the pipe is ready to be used within an hour.
Temperature range – continuous
-45°C to 200°C
Temperature range – intermittent
-65°C to 260°C
700 psi min
400 Vpm min
1 x 1013 OHMs/cm
Approximately 10 – 12* bars
81 21 75**
* requires multiple layers application
** code of similar product
Amount in a box
25 mm x 5m
38 mm x 5m
50 mm x 5m
Clean the repair surface from dirt, oil etc. before the application.
Attach the beginning of tape close to damage area and start wrapping around (with tension).
Keep stretching the tape, and continue installation with 50% overlap. It will fuse to itself after overlapping.
Finish the wrapping over the problem area and once finished press the end firmly into place.
For high pressure leaks, additional wrapping may be required. Most hose repairs can be repaired with 3-5 layers in thickness, and wrapping 3 to 5 inches in each direction away from the leak point; however, additional strength can be added simply by wrapping more layers of the MF50 tape.
For electrical wiring, it is not necessary to stretch tightly. In fact, it will be more resilient to abrasion when it is not stretched as tightly.